Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: trompounder on October 30, 2017, 10:10:41 PM

Title: Not enough memory
Post by: trompounder on October 30, 2017, 10:10:41 PM
Hello, i've seen some messages about this error on this forum, but i think that no one aswers to my call of help.

So i have a model with 132 photos, with a total of 655Mb (around 5Mb each photo). My computer have an i7 CPU, the GTX970 STRIX 4GB DDR5 graphics card, and 32Gb RAM, but when i do the mesh, even on low quality, it says that i have not enough memory. I Already tried to do all of the workflow on low and it's the same.

Please Help me how to figure out this error.
Title: Re: Not enough memory
Post by: Alexey Pasumansky on October 31, 2017, 01:12:15 AM
Hello trompounder,

Please provide the processing log related to the operation and specify the image resolution and the number of points in the dense cloud.

Also what type of the project you are processing - aerial survey data or close range project?
Title: Re: Not enough memory
Post by: Rudy1Otter on December 22, 2017, 06:41:10 PM
In Windows, disabling some processes using a lot of memory  (in the Task Manager) sometimes worked, but my best results were gained by running Agisoft Photoscan in Safe Mode.  Absolutely no more Not Enough Memory messages since I started doing that.  You probably already know this, but put you PC into Safe Mode by restarting the computer, all the while tapping F8 while it starts, and then selecting Safe Mode.  If you still get a Not Enough Memory message, then I don't think your computer can handle processing in Photoscan with your chosen parameters.