Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - trompounder

Pages: [1]
1
Bug Reports / Not enough memory
« on: October 30, 2017, 10:10:41 PM »
Hello, i've seen some messages about this error on this forum, but i think that no one aswers to my call of help.

So i have a model with 132 photos, with a total of 655Mb (around 5Mb each photo). My computer have an i7 CPU, the GTX970 STRIX 4GB DDR5 graphics card, and 32Gb RAM, but when i do the mesh, even on low quality, it says that i have not enough memory. I Already tried to do all of the workflow on low and it's the same.

Please Help me how to figure out this error.

Pages: [1]