Forum

Author Topic: Request: Automatic re-positioning 3d model (standard)  (Read 2107 times)

Toshi_OK

  • Newbie
  • *
  • Posts: 30
    • View Profile
Request: Automatic re-positioning 3d model (standard)
« on: October 13, 2017, 06:40:45 AM »
Hi Agisoft Developer Team,

I have a request for future function for Standard version.
Could you consider to add "Re-positioning 3D Model based on current model view" option?

Please see the attached photo for your reference.

If optimizing a model position according to current view, it makes very very helpful for exporting to other 3d software and for 3d printing. Please consider below my request for future update.

According to current model view,
1: set the base of region under the model and fit the region size.
2: set the model position at the center of local coordinate
3: set the model angle based on current view

Thanks a lot for looking at this post.
Toshi

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Request: Automatic re-positioning 3d model (standard)
« Reply #1 on: October 13, 2017, 03:23:11 PM »
Hello Toshi,

In the version 1.4 (currently available as pre-release: http://www.agisoft.com/forum/index.php?topic=7730.0) we have added Move Object and Scale Object instruments in addition to Rotate Object. All these three instruments can be applied to the unreferenced models and work in both editions of PhotoScan.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Toshi_OK

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: Request: Automatic re-positioning 3d model (standard)
« Reply #2 on: October 16, 2017, 07:31:18 AM »
Hi Alexey,

Thank you for your reply.

I was thinking if the automatic repositioning was added, it was fantastic for scanning models.

I understand It may be difficult to define the region and angle, however, I am very glad that if you still consider and add "One Button" action for that manipulation for future.

Thanks for looking and considering this request.

Best wishes,
Toshi