Agisoft Metashape > General
Workflow to process the Photography of "PHANTOM 4 RTK"
Domingo:
Hello partners:
I am trying to process a set of photographs taken with the Phantom 4 RTK.
The photographs have in their metadata the precisions in XYZ with which they were made.
When I upload the photos in the PhotoScan 1.4.3 does not recognize that data, it gives me the precision that PhotoScan has by default. 10 meters.
I have tried to load the same photos in Pix4D, if you load the precisions of XYZ (attached photograph).
Can someone tell me the workflow to process the photos taken with the Phantom 4 RTK?
Thank you very much for your cooperation and sorry for my English.
Greetings.
Alex737:
Where can I download photos taken by phantom 4 rtk?
3DFranz:
I can give it also a try, If you can share the fotos.
Be sure that you have checked (under PhotoScan settings) "load xmp Data..."
Domingo:
--- Quote from: Alex737 on October 31, 2018, 07:48:45 AM ---Where can I download photos taken by phantom 4 rtk?
--- End quote ---
Attached link to download the file with 18 photographs taken with the Phantom 4 RTK, as well as, all the files generated by the drone.
https://we.tl/t-fQ3g2XPNRG
Domingo:
--- Quote from: 3DFranz on October 31, 2018, 10:18:44 AM ---I can give it also a try, If you can share the fotos.
Be sure that you have checked (under PhotoScan settings) "load xmp Data..."
--- End quote ---
Yes, I have the "load xmp Data ..." option activated
But when I add the photos, the precision it gives me is 10 meters, the standard configuration of Photoscan (attached image)
Navigation
[0] Message Index
[#] Next page
Go to full version