Agisoft Metashape
Agisoft Metashape => Face and Body Scanning => Topic started by: narayans on January 29, 2019, 04:01:35 PM
-
To improve alignment, I've placed markers on my model's earrings. So wherever her left earring shows up in one of the photos, I place a marker. Same for the right earring.
I was a bit concerned about this because the perspective of the earrings changes as the model rotates.
And as they are round pearl earrings, I thought this might not work.
Indeed, my alignment worsened. Really bad.
Anyone else have experience with this?
Should I have stuck a few flat markers on her face while I was shooting?
What's the protocol?
-
Hello narayans,
From what I have seen, scanning studios are usually using small dots put on the actors face, like on this picture:
https://www.fxguide.com/wp-content/uploads/2013/11/emilymaths-320x216@2x.jpg
Or in this post: http://ir-ltd.net/triplegangers-is-back/
Currently Metashape Pro doesn't support spherical targets (that assume the coordinates of the target in the center of it).