Agisoft Metashape

Agisoft Metashape => General => Topic started by: Erik Holmlund on July 16, 2019, 05:18:25 PM

Title: Change default CRS shift settings?
Post by: Erik Holmlund on July 16, 2019, 05:18:25 PM
Hello,

The coordinates of the CRS I use are too big to export in a binary format, so I always apply a global shift to my exported dense clouds and models. This shift is constant for my work area, so I can conveniently remember the number in my head. I recently found the "Load Defaults" button close to the shift settings, which gives reasonable numbers, but varies from the setting I normally use.

Is there any way of changing this setting? If not, it would be an incredibly useful feature!

Attached is a screenshot of it.

Kind regards,

Erik