Agisoft Metashape
Agisoft Metashape => General => Topic started by: toxicmag on August 29, 2019, 12:12:02 PM
-
Dear members,
do you also experience the panel detection of Micasense cameras failing in NIR-channel?
Latest Metashape (1.5.4) is used, but this issue was also seen in 1.5.3. (see attachments).
Taking the calibration photos from shorter distances shows the same effect.
Usually i then start toggling through the bands and do manual masking, but the general questions are:
1) Is the NIR channel being used in the calibration at all?
2) Will manual masking solve the issue properly?
Thanks for your replies.
Alex
-
Hello Alex,
We have not observed that on the datasets that we use for testing. Can you share the two images (Blue and NIR bands) where the panel is detected differently?