Agisoft Metashape

Agisoft Metashape => Face and Body Scanning => Topic started by: NISHANTBIMAL on February 18, 2020, 09:22:13 AM

Title: Not getting good result in metashape pls help
Post by: NISHANTBIMAL on February 18, 2020, 09:22:13 AM
Hi I have 20 set of images which I m trying to make object from it in metashape but I m not getting result but I have seen people using same image as get good results can help out where I m doing wrong.
Image link https://we.tl/t-xPIETt1BlY
Title: Re: Not getting good result in metashape pls help
Post by: Alexey Pasumansky on February 18, 2020, 01:05:29 PM
Hello NISHANTBIMAL,

Which camera have you been using?
Title: Re: Not getting good result in metashape pls help
Post by: NISHANTBIMAL on February 18, 2020, 01:19:57 PM
I don't now man I just downloaded this image set they has shown good results from this images but I m getting some orientation
 issue in metashape but my friend tried this same image on reality capture he is getting some decent result
Title: Re: Not getting good result in metashape pls help
Post by: Alexey Pasumansky on February 19, 2020, 10:04:06 PM
Hello NISHANTBIMAL,

It seems that the overlap between the images is not sufficient for stable alignment results. There are only 18 different images (while at least 25-35 images per circle around the object are recommended) in the set. Also the EXIF information is missing. It seems that the zoom lens has been used, which means that it might be better to split the calibration groups prior to the image alignment, otherwise they will be stacked to the same calibration group and the autocalibration results would be incorrect.