Agisoft Metashape

Agisoft Metashape => Feature Requests => Topic started by: carlhenriksson on July 14, 2020, 04:43:47 PM

Title: Selecting regions to be used for alignment between chunks
Post by: carlhenriksson on July 14, 2020, 04:43:47 PM
Hi

Is it possible to isolate regions of two difrent chunks to be used to match the alignemnt between them. I basically only want thoose regions to be taken into acount when point alignment is done for the chunk alignment, ( since other parts of my chunks are moving ). If not , a feature like that would be awsome.

Best

Carl
Title: Re: Selecting regions to be used for alignment between chunks
Post by: Eric Baird on December 01, 2020, 08:12:12 PM
yep
Title: Re: Selecting regions to be used for alignment between chunks
Post by: JMR on December 02, 2020, 10:24:55 AM
Can be done by masking, but a strighter method would be welcome.