Agisoft Metashape

Agisoft Metashape => General => Topic started by: Invaidor on February 26, 2021, 12:11:18 PM

Title: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on February 26, 2021, 12:11:18 PM

Hi

I noticed an differance in point cloud from old Agisoft and new metashape.
Im creating point clowk over an low forest area <5meters height of trees, and the tops of trees gets shopped off/rounded in metashape.
I'm running the same settings, well there arent that many settings to choose from more thatn qualety and filtering.
I have run both in meduim and mild.

Metashape produced a whole lot less noice than old agisoft witch is good.

Any ideas? Whats should I do differant?

Allign photos, medium, reference, Key 40'000, Tie 4000. Photo accuracy 0,1meter.
Optimize cameras
Build dense clud, medium quality, mild depth filtering.

I get differant output with lower height on trees in Metashape.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on March 02, 2021, 11:01:03 AM

See the differance with the same settings in all steps on both versions.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: MaciekK on March 02, 2021, 11:06:52 AM

you have 15 million points on one cloud and 101 million on the other - maybe that's the difference

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on March 02, 2021, 02:08:01 PM

I have tryed all different qualety settings in Metashape, non of them look like Agisoft dence cloud.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Alexandros21 on March 02, 2021, 02:39:10 PM

The difference in points count is huge. Are you sure you didn't use high quality settings in the old Agisoft? Also, which version is the old Agisoft and which the Metashape that you tried?

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on March 02, 2021, 03:17:58 PM

Nope same settings in both..
The Agisoft version was Agisoft 1.2 and Metshape 1.7.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Alexey Pasumansky on March 03, 2021, 07:05:15 PM

Hello Invaidor,

If possible, please share the original image set that you are using for this project (or any other project where the difference is considerable) to support@agisoft.com, so that we could reproduce the difference and investigate the source of it. Additionally please share the PDF reports exported from both projects.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on March 05, 2021, 02:07:53 PM

Yes an email with the related data is sent to support adress.

Title: Re: Differance in point cloud from old Agisoft and Metrashape
Post by: Invaidor on September 13, 2022, 02:22:11 PM

@Alexey Pasumansky, do you have any news in this issue?