Agisoft Metashape

Agisoft Metashape => General => Topic started by: Brit on March 17, 2021, 01:00:56 AM

Title: Where did the camera rectangles go?
Post by: Brit on March 17, 2021, 01:00:56 AM
Hello, for some reasons I'm missing those little rectangles that show the placement of the cameras after the alignment phase. Any suggestions?
Title: Re: Where did the camera rectangles go?
Post by: Alexey Pasumansky on March 17, 2021, 01:29:58 AM
Hello Brit,

If you are in Model view mode, press Show Cameras button on the toolbar to make the camera placeholders appear. You may also need to use Reset View button, if you do not see anything in the Model view after processing operation is completed.
Title: Re: Where did the camera rectangles go?
Post by: Brit on March 19, 2021, 01:45:25 AM
Thanks!