Agisoft Metashape

Agisoft Metashape => General => Topic started by: Rawf on April 23, 2021, 07:16:38 PM

Title: Question about report after Alignment
Post by: Rawf on April 23, 2021, 07:16:38 PM

Hello, I would like to know what kind of filtering the software does after alignment so it gives me X amount out of Y Points on the Tie Point report. I mean how the program decides that these Y-X points  are not eligible to be to the final Tie Point Cloud.

I'm a Land Surveyor engineer student and I do a research using this wonderful software in the progress of my diploma thesis.
Thank you in advance for your time to response to me