Agisoft Metashape
Agisoft Metashape => General => Topic started by: AndrejH on May 13, 2021, 03:42:56 PM
-
Good afternoon!
Mr. Pasumansky I'm kindly asking you to let me know what method is used for transformation between coordinate systems in Metashape? My colleagues and I think that it might not be only a 7 parameter transformation, but some kind of polynomial. Could you please confirm or deny this? Could you please tell me more about the method you use?
Kind regards,
AndrejH
-
Hello AndrejH,
Metashape is using 7-parameter Helmert transformation in geocentric domain.
Please refer to pages 108-109 of the following document:
https://www.iogp.org/wp-content/uploads/2019/09/373-07-02.pdf