Agisoft Metashape

Agisoft Metashape => General => Topic started by: flightfollowing on June 21, 2013, 03:16:14 PM

Title: Camera correction and pitch roll yaw input values used for alignment yet?
Post by: flightfollowing on June 21, 2013, 03:16:14 PM
Are the values of pitch, roll, yaw, and X Y Z (offset?) input in the Camera Correction screen of alignment enabled in 0.9.1?
I have precise values for these parameters (quality GPS/IMU) and seem to be getting mixed results in enabling camera correction for the alignment output when using them. Does anyone know if this is enabled, and if so, best strategies to use it?
For example, if the pitch error from input values to output values in a good project is about a 1 degree offset, ( 1 degree plus or minus about 1 degree)  is it useful to enter a pitch correction of 1 degree (or 179 degrees since the initial is always 180 degress?) in the same project or subsequent projects using the same GPS/IMU geometry?
This post is somewhat an extension of post:
http://www.agisoft.ru/forum/index.php?topic=370.0

which indicated camera correction was not enabled back in 0.8.5

Thanks
Title: Re: Camera correction and pitch roll yaw input values used for alignment yet?
Post by: Alexey Pasumansky on June 21, 2013, 03:32:07 PM
Hello flightfollowing,

Camera correction section in Ground Control pane setting dialog is working, but effects only on estimated orientation angles.
Source values for orientation angles are not used in processing for 0.9.1 version.