Agisoft Metashape

Agisoft Metashape => General => Topic started by: Brit on July 09, 2021, 02:06:10 AM

Title: mesh appeared to "explode"
Post by: Brit on July 09, 2021, 02:06:10 AM

For some reason my seemingly normal dese cloud of a high Utah ridge scan seemed to "explode" with hundreds of small spheres floating around the ridge, which was ill defined when the bits were removed. Any ideas?

Title: Re: mesh appeared to "explode"
Post by: Alexey Pasumansky on July 09, 2021, 02:16:50 AM

Hello Brit,

Which Metashape version do you use and which mesh generation settings have been selected in this project?

Also please specify, if the alignment results are correct, or whether you see that some cameras are aligned incorrectly or even the alignment is split into several poorly connected components.

Title: Re: mesh appeared to "explode"
Post by: Brit on July 09, 2021, 03:36:49 AM

>"Which Metashape version do you use and which mesh generation settings have been selected in this project?

It's 1.7.1. I'm updating now.

>Also please specify, if the alignment results are correct, or whether you see that some cameras are aligned incorrectly or even the alignment is split into several poorly connected >components."

I'm not quite sure what this means. How do I know if they are correct?

Do I optimize cameras?