Agisoft Metashape

Agisoft Metashape => Camera Calibration => Topic started by: aag_frei on July 16, 2021, 11:50:56 AM

Title: Placing markers increase cameras error after optimization
Post by: aag_frei on July 16, 2021, 11:50:56 AM
To whom it may concern,

I have several data set of pictures taken with a DJI drone at different heights and dates which I add to the project and have an acceptable error. However, as soon as I place the markers and optimize allignment, the cameras error rockets.

I have tried fixing the f value in the camera calibration menu since in the adjusted tab it was twice what it was in the initial tab, but that did not help.

Does anyone know why does that happen and how to fix it?

Thank you in advance!