Agisoft Metashape

Agisoft Metashape => General => Topic started by: metashape.td on August 02, 2021, 09:51:25 PM

Title: [solved] Volume calculation "fails" because volume is to small
Post by: metashape.td on August 02, 2021, 09:51:25 PM

We are trying to measure the volume of peat moss capitula using a low cost scanner and Metashape. We are quite satisfied up to know, but some of the measurements fail because the volume of the capitula is to small. The volume is simply 0.0 if it is below 1e-8 or so.

Is it prossible to set a higher precision for volumes smaller than e-8?

Title: Re: Volume calculation "fails" because volume is to small
Post by: metashape.td on August 03, 2021, 08:19:29 PM

I had an error within my script. It does work now with an R² of 0.92 to 0.97.