Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: wojtek on December 25, 2021, 03:55:04 PM

Title: Error: bad locale name (not sure if this is a bug)
Post by: wojtek on December 25, 2021, 03:55:04 PM
I've gotten this error a couple of times when saving in the latest 1.8.0 build. Can you guys elaborate a bit on what this is about?
Title: Re: Error: bad locale name (not sure if this is a bug)
Post by: Alexey Pasumansky on December 25, 2021, 09:08:04 PM
Hello wojtek,

please check the newly published 1.8.0 pre-release (build 13736), do you still observe locale name issue?
Title: Re: Error: bad locale name (not sure if this is a bug)
Post by: wojtek on December 26, 2021, 11:24:37 AM
Installed the new build and tested on the same project, saved properly this time.