Agisoft Metashape

Agisoft Metashape => General => Topic started by: ArchArch on April 22, 2022, 02:56:00 AM

Title: Smoothing boundaries between drone flight paths on DEM
Post by: ArchArch on April 22, 2022, 02:56:00 AM
I've created a textured model based on drone imagery and then built/exported a DEM in Metashape. However, there are pronounced ridges along the edges of my flight path areas, appearing as if showing the edge of a terrace. How can I smooth these seams/ridges? They should be apparent in the attached image. Any advice is appreciated!
Title: Re: Smoothing boundaries between drone flight paths on DEM
Post by: Paulo on April 22, 2022, 09:39:38 AM
I think these ridges are evidence of misalignment between different flights...

so you should revisit alignment and overlap between different flights.....
Title: Re: Smoothing boundaries between drone flight paths on DEM
Post by: ArchArch on April 23, 2022, 08:06:24 PM
Good point. Thank you Paulo!