Agisoft Metashape
Agisoft Metashape => General => Topic started by: MurrayW on May 24, 2022, 12:55:42 PM
-
Hi everyone,
I am looking for a method to generate a quick orthomosaic, so color can be checked and adjusted prior to the final mosaic.
I have 5400 images from FujiFilm GS100 100 MegaPixels)
I have psx project with 1100 of the 5400 images. It is aligned, optimised, Dense Pt Cld, Mesh, all ready to go to mosaic - that takes 7 hours.
But the colors differences between images are large due different dates, sun-angle, atmospheric conditions, etc.
I made some low resolution images, and made a new psx with those.
I did the usual process and could generate a low-res mosaic in 2 minutes
I would like to import the EO (XYX/OPK.csv) from the accurate high-resolution psx - in place of the whole allign/optimise etc process with the low-res images
I hope to import and accept the EO
Also import a mesh or DEM, create a camera calibration, then run mosaic
But not sure how to tell metashape to accept the imported EO.
MetaSHape 1.7.5 build 13229 (64 bit)
regards
Murray
-
Hello MurrayW,
you can look at https://github.com/agisoft-llc/metashape-scripts/blob/master/src/quick_layout.py. This let's you set the EO of images according to imported reference values (XYZ YawPitchRoll)...
it should get you going