Agisoft Metashape

Agisoft Metashape => General => Topic started by: Tobi_Passau on June 29, 2022, 03:49:09 PM

Title: Loosen up requirement for matching with manually places markers
Post by: Tobi_Passau on June 29, 2022, 03:49:09 PM
Hello,

the manual says: "Set markers (at least 4 per images) on these images and indicate their projections on at least two
images from the already aligned subset.".

I can't. The images were shot with too little overlap and the area I have to do is no longer accessible for me. Is there any way to it with only one already aligned image?

Greetings
Title: Re: Loosen up requirement for matching with manually places markers
Post by: DayGeckoArt on July 01, 2022, 08:37:22 AM
Place your markers and see what happens. There's no requirement, I've had ground control points on only single photos
Title: Re: Loosen up requirement for matching with manually places markers
Post by: Tobi_Passau on July 01, 2022, 10:57:41 AM
I'm doing this all the time. The software doesn't align the photos or merges the components.