Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: San Seon on November 23, 2022, 11:53:24 AM

Title: How to keep camera position and rebuild Tie points?
Post by: San Seon on November 23, 2022, 11:53:24 AM
Hi,

I'm trying to align interior picture with a lot of reflections in the area.

Most of cameras are aligning fine but few of them fly out wild.

I'd like to manually disable those cameras and rebuild the tie point but without resetting camera position.

If I reset the whole thing, because there's few photos disabled, some more camera runs off. Not ideal.

Is there a way of doing this?

Thanks!


ps. I tried to delete tie points and run "align photos" without "Reset current alignment". It doesn't make any tie point after running for few hours :/
Title: Re: How to keep camera position and rebuild Tie points?
Post by: James on November 24, 2022, 03:54:52 PM
I think 'Tools -> Tie Points -> Build Point Cloud...' is what you are looking for