Agisoft Metashape

Agisoft Metashape => General => Topic started by: KEgg on June 21, 2011, 05:24:35 PM

Title: Quality of Merged Chunks
Post by: KEgg on June 21, 2011, 05:24:35 PM
Hi there,

Having an issue with the final merged output and its quality. Should there be some sort of dialogue that pops up asking the likes of the detail, poly count and overlap reduction before it does the job?

The final output comes across a little too lacking in detail.  :o

(http://www.pasteall.org/pic/show.php?id=13989)

best regards

MikeH
Title: Re: Quality of Merged Chunks
Post by: Alexey Pasumansky on June 21, 2011, 06:14:23 PM
Hello Mike,

Thank you for this issue. We will take into consideration the possibility of adding quality settings for chunk merging procedure.
Title: Re: Quality of Merged Chunks
Post by: janosch1234 on September 16, 2011, 07:14:32 PM
Hi Alexey,

do you have any news on this?

I tried merging 3 chunks today and the result of the merged mesh still misses a lot of detail compared to the original meshes.

Best Regards
Jan
 
Title: Re: Quality of Merged Chunks
Post by: wj on September 17, 2011, 11:45:48 AM
The same problem: ) 
Title: Re: Quality of Merged Chunks
Post by: kris3d on November 10, 2012, 10:56:29 PM
I know it's an old post.
But the problem is still not fixed.
The combined cuts, have poor quality fuzzy.
It seriously limits the possibilities of the program.
How it will be repaired, the memory limitations are no longer an issue.
You will be able to build a huge scene

I beg you amend your same functions?