Agisoft Metashape

Agisoft Metashape => Camera Calibration => Topic started by: Nathan Craig on June 21, 2011, 07:56:48 PM

Title: Square Pixels and Center Principal Point
Post by: Nathan Craig on June 21, 2011, 07:56:48 PM

In the Calibration dialogue, there is an option to set Square Pixels. The word square is not presently found in the PDF version of the manual for Agisoft Lens. In the manual, under the section on calibration parameters there is a discussion of fixed aspect ratio. Does this option relate to the square pixels option? Likewise, the manual discusses "Fix Principal Point" while the options dialogue box reports Center Principal Point. Should I assume that these are likewise related?

Thanks in advance for any clarification that can be offered.

Regards,
Nathan

Title: Re: Square Pixels and Center Principal Point
Post by: Alexey Pasumansky on June 22, 2011, 05:49:29 PM

Hello Nathan,

Thank you for the question. We have corrected AgiSoft Lens manual on our site.

Title: Re: Square Pixels and Center Principal Point
Post by: Nathan Craig on June 23, 2011, 12:13:54 AM

Dear Alexey,

Thank you, this is much clearer now.

Regards,
Nathan