Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: andyroo on January 23, 2014, 06:39:49 AM

Title: cancelling orthophoto creation waits until color correction finished
Post by: andyroo on January 23, 2014, 06:39:49 AM
I just found out that if I hit cancel right after the raster size to be created is displayed, the color correction calculation has already started and I have to wait tens of minutes until it finishes. Or maybe I have to wait until the raster builds. Either way I hit cancel 20 minutes ago, and it's still chugging away as I type this.

This is sort of an "additive" bug, since it wouldn't be a problem for me except I already know that the jpg is going to fail, since the max dimension is greater than 65535, but before color correction came around, I used to be able to cancel raster creation once I saw the grid was too big. Now color correction starts right away, and apparently I have to wait until that's done. ugh.

--edit - I posted the logfile below to illustrate my issue. Bold underlined is what told me to hit cancel (max dimension was 75862, which will cause a .jpg raster build to fail after going through all the motions) Bold is what I saw sitting on the screen after I hit cancel. (last thing showing was "collecting control points..."

Non-bold text is what showed up at the end after another 22 minutes or so...

initializing renderer... tessellating mesh...done (39891889 -> 39891889 faces)
done in 92.613 sec
Raster size: 25055x75862
Estimating mosaic occupancy...
1 blocks used from 1x1 (100%)
Calculating color correction...
collecting control points...
collected 11412195 points in 280.025 sec
analyzing 395 images... *Error: aborted by user
*Error: aborted by user
*Error: aborted by user
*Error: aborted by user
*Error: aborted by user
*Error: aborted by user
*Error: aborted by user
*Error: aborted by user
Error: aborted by user
Finished processing in 1241.76 sec (exit code -1)

>>>
Title: Re: cancelling orthophoto creation waits until color correction finished
Post by: frejus on March 12, 2015, 02:14:40 PM
Same for me here, I am hitting the "cancel" button when system is doing color corrections, and it just would no stop.
It says 100% done, but it would not stop. I have 400 pics of 2 mega pixels each, mesh was done quickly.

Clicking on Pause makes the button greyed out for a few seconds than comes back active and nothing happen.

So I am getting stocked on the final step and cannot get end result... Too bad.
Title: Re: cancelling orthophoto creation waits until color correction finished
Post by: Alexey Pasumansky on March 12, 2015, 02:22:28 PM
Hello frejus,

Color correction operation includes some steps that cannot be canceled until finished.