Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: Bruno Andrieu on April 05, 2014, 05:45:39 PM

Title: cannot build dense point cloud from imported camera postion and calibration
Post by: Bruno Andrieu on April 05, 2014, 05:45:39 PM

Hello

After having build a point cloud, I exported the camera (positions) and calibration.
Now I build another chunk with the same images (a subset of them).  I  import cameras position and calibration. I do not re-align cameras because I want to use the imported positions.

But photoscan cannot build the dense point cloud in these conditions. What is wrong ?
Thx

Title: Re: cannot build dense point cloud from imported camera postion and calibration
Post by: Alexey Pasumansky on April 05, 2014, 06:21:06 PM

Hello Bruno,

After you import cameras you need to use Build Points dialog. If you cancel that no tie points will be found and PhotoScan will not have any imformation regariding overlapping images.

Title: Re: cannot build dense point cloud from imported camera postion and calibration
Post by: Bruno Andrieu on April 05, 2014, 07:07:17 PM

Hello Alex

I understand.  Does it mean also that photoscan will not use the imported camera positions , and will recalculate the camera positions ? (I use fixed calibration option for the lens). I would like to be able to impose imported camera positions as well.



Hello Bruno,

After you import cameras you need to use Build Points dialog. If you cancel that no tie points will be found and PhotoScan will not have any imformation regariding overlapping images.