Agisoft Metashape
Agisoft Metashape => General => Topic started by: Peter on June 16, 2014, 06:20:53 PM
-
Any idea how i can get the mesh build not in the way shown in pictures?. I would like my mesh to go in an straight line and not upwards as that does not look that way in real life
-
What interpolation are you using when building mesh? Its in Advanced submenu in Build Mesh. Try using disbled. Also, you are using masks ? Try masking unwanted areas. Third that might help you is to delete unwanted points from Dense point cloud.
HTH,
Admir
-
The problem for me is that agis dosent make the mesh based on the lower points that are visiblen and instead goes "high" and the i get the slope that are not supposed to be there.
I gues there that it makes the mesh to areas with high enogh point count or someting
-
I decided to manually mask out the water on the images rather than manually deleting points from dense point cloud before doing the mesh as i did in the images above
I think masking out the water is the better options
-
You should use Build Mesh - Arbitrary - Source Data : Dense Cloud-
Then you'll get a mesh that is simmilar to your dense cloud.
Surface type : Height field is only 2D + 1
Surface type: Arbitrary is 3D