Agisoft Metashape
Agisoft Metashape => General => Topic started by: zsoooc on October 08, 2014, 11:48:22 AM
-
Hello,
I have a question about aligning photos.
I'm working with a DJI Phantom FC200 camera. I would like to make an orthophoto about a new motorway. One row with about 700 images. The overlap is about 80%.
I use PS 10.0.4 version (and tried 1.1).
1. I loaded about 80 photos, then loaded the camera calibration xml file.
2. I run align photos command with these settings: accuracy: high, pair preselection: ground control
The alignment was successful, but the result is very bad, I attached the image. I tried with pair preselection disabled, but the result is the same.
I attached the result.
What can be the source of the problem?
-
My experience, flying a single flightline is always problematic