Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: John Wells on November 23, 2011, 09:39:56 PM

Title: Model failure
Post by: John Wells on November 23, 2011, 09:39:56 PM

I have constructed a model with only two images, only to find if I try to do the same again in the same session, with the same images, the modelling fails.  If I reboot the computer, the model can again be constructed.... once.  Is this a memory problem.
My computer is an Lenovo Ideacentre i3.

Title: Re: Model failure
Post by: Alexey Pasumansky on November 25, 2011, 06:07:45 PM

Hello John,

Are you using PhotoScan on 32-bit  system? And does "Not enough memory" message appears when building geometry fails?

Title: Re: Model failure
Post by: John Wells on November 25, 2011, 07:14:16 PM

Hi
It is a 64-bit, i3 system with 4GB RAM. No memory warnings.

Title: Re: Model failure
Post by: Alexey Pasumansky on November 28, 2011, 03:53:01 PM

Hello John,

How many points are there in the point cloud and do you rebuild the cloud each time before reconstructing the geometry?

If it is possible please provide us this project with two photos (please send it to support@agisoft.ru) and we'll try to investigate the problem.