Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: virtek on October 29, 2015, 01:48:11 AM

Title: different behaviour of the build dense cloud process
Post by: virtek on October 29, 2015, 01:48:11 AM

hi,

in PhotoScan 1.2.0 build 2172 after aligned (generic or referenced it doesn't matter, both checked) something strange is going one in dense cloud process.
Maybe this is cause by two sets of photos from different heights (30 AGL and 140 AGL) but if it's aligned and tie points looks good, the dense point cloud doesn't.

Title: Re: different behaviour of the build dense cloud process
Post by: Alexey Pasumansky on October 29, 2015, 08:16:44 AM

Hello virtek,

It seems to be an alignment issue, not a problem of the dense cloud. The subsets of photos taken from the different altitude were not correctly aligned with each other.