Agisoft Metashape
Agisoft Metashape => Bug Reports => Topic started by: Herman on December 03, 2015, 08:26:20 AM
-
Good Day,
I am experiencing a problem that it is a bit strange, two of my pojects, (.psz files) do not not open correctly. I can open the files, and photoscan starts to open it, but then the program stops responding. I have tried leaving the projects on for quite a few hours, but still no luck. the two file sizes are 7.3gb and 3.6gb respectively, and we have done much bigger projects, so I am unsure what caused this.
Anyone have any ideas as to what I can do? I would like to recover the two files, since my backups are saved at a point before I built my mesh and classified ground points, so it will take a while to rerun those processes.
Other than this little problem, the software is great! thanks guys
-
Hello Herman,
I can suggest to turn off "Switch to the model view by default" option in the Preferences window and then re-open the project.
Possibly there is a huge number of polygons in the model, and the graphic card is not able to handle it.
-
Hello Alexey,
Thank you very much for the quick response, I switched of the model view by default and that did just the trick!!
Once again I must just say, Brilliant product, Brilliant Service!! 10 out of 10
Thank you