Agisoft Metashape

Agisoft Metashape => General => Topic started by: olihar on May 09, 2012, 08:07:30 PM

Title: Creation of DEM
Post by: olihar on May 09, 2012, 08:07:30 PM

Ok so I am trying to understand the DEM export better.

When I export DEM does it recompute the model, does it not use the 3D model already reconstructed.

Reason I am asking I am doing some tests and it takes around 45GB of RAM to export a fairly small area, it is like it is reprocessing the model.

Edit: So if I put lower value then default given value it will do this heavy process.

Title: Re: Creation of DEM
Post by: Alexey Pasumansky on May 11, 2012, 03:41:11 PM

Hello olihar,

Export DEM doesn't rebuild the models geometry.

Could you please specify the number of faces in the model and the export resolution selected?