Agisoft Metashape
Agisoft Metashape => General => Topic started by: ihabali on April 24, 2016, 06:34:40 PM
-
Hello,
I'm sure I missed something in the manual about this but is there a way to mark a camera so it does not contribute to point cloud/mesh creation or texture but is just there to be aligned relative to the generated model and the rest of the cameras?
I basically created a model from a group of still but would like to align a video camera(using a single frame still) so I can use that camera's position to project a video on portions of the generated model(all this will be done in C4D)
Regards,
Ihab
-
Do you mean to disable a camera? You have a red no way sign button you can use after alignment. It will prevent this camera to be considered for any further process if I understood you well.