Agisoft Metashape
Agisoft Metashape => Bug Reports => Topic started by: Infinite on July 24, 2012, 04:06:52 PM
-
If a user right clicks on marker in 2d photograph and selects Remove marker, markers still appears on photograph? should it not be removed entirely? or placed out of the photo range? It's hard to know if a marker is being used or not?
-
Hello Lee,
When you use Remove marker command in 2D Photo view, the marker turns grey - this means that this projection will not be used in calculations anyhow. It is just visualization of the estimated marker position.
-
Hello Lee,
When you use Remove marker command in 2D Photo view, the marker turns grey - this means that this projection will not be used in calculations anyhow. It is just visualization of the estimated marker position.
Hello Alexey, at the moment all my markers are light grey? if I select it turns red, if I right click it goes light grey again, if I do remove on a marker it stays the same colour and moves position slightly?
-
Hello Lee,
If they are grey that means there no markers, but only their estimated locations (based on projections on the other photos). But if you left-click on them they will turn to real marker projection (blue flag).
-
Hello Lee,
If they are grey that means there no markers, but only their estimated locations (based on projections on the other photos). But if you left-click on them they will turn to real marker projection (blue flag).
Hello Alexey, understood my mistake, thanks for clarification.