Agisoft Metashape
Agisoft Metashape => General => Topic started by: Art on December 07, 2016, 04:05:19 AM
-
Hi
Is it possible to have automatic marker detection for generic GCPs like crosses for aerial imagery? I'm trying to use the coded markers but I can't seem to get PS to recognise the markers despite printing them to larger than A0 and flying at 50m AGL. Any suggestions?
Cheers
Art
-
Hello Art,
In the following document you can find two types of the non-coded targets that can be detected by the actual version of PhotoScan:
http://www.agisoft.com/pdf/PS_1.1_Tutorial%20(IL)%20-%20Coded%20Targes%20and%20Scale%20Bars.pdf
The detection of non-coded targets should be performed after the camera alignment and may require manual target renaming after they are detected.