Agisoft Metashape
Agisoft Metashape => General => Topic started by: geochina on August 31, 2012, 11:43:59 AM
-
I use photoscan to process aerial images?but I get the point clouds that is not a flat,is the arc of point clouds. How to solve this problem ? This is alignment error?
-
Bad calibration.
Autofocus enabled?
Sensor-shift or lens shift IS enabled?
-
Hello geochina,
In case of such aligning results of aerial data we recommend to optimize the photo alignment using camera coordinates (if any) with the corresponding Camera Accuracy parameter in the Ground Control settings.
Some times several optimizations is required to fix such "bowl-effect".
-
Geochina good afternoon. Could you correct the problem of the bowl effect? We have a similar problem with a strip of 30 kilometers. Regards
Eduardo