Agisoft Metashape

Agisoft Metashape => Camera Calibration => Topic started by: Mina on July 11, 2017, 12:12:09 PM

Title: Errors of calibrated parameters
Post by: Mina on July 11, 2017, 12:12:09 PM
Hello everyone,

Since I was not completely satisfied with autocalibration results of PhotoScan, as I did not clearly understand, how its algorithm works, I have decided to calibrate the camera beforehand using the Agisoft Lens.
Here is the results of my initial trial; but I did not know how to interpret the plots of radial and tangential distortion? If the displayed errors of calibrated parameters are low, it means that the calibration results are satisfactory?

any comments would be great. Thank you!