Agisoft Metashape
Agisoft Metashape => General => Topic started by: patcarbon on October 16, 2012, 04:22:08 PM
-
I'm processing a 2000 image project. The surface is quite self-similar and aligning the entire project in 1 chunk was a disaster (see below). So I'm having to use several chunks. I'm now on 7 chunks (which correspond to 7 UAV flights) and I'd like to end up with 1-2 chunks before I optimise.
Is it possible to use markers to performa an initial chunk alignment and then have a point-cloud match to reffine this alignement? Does the 'points' align option just delete any previous alignment?
thanks
Patrice
-
Yes, is a low overlap, next time use higher = 60 - 80 % afther that can disable images from there..
And is possible set custom POINTS, without precise data, then try ALIGN again.....