Agisoft Metashape

Agisoft Metashape => Feature Requests => Topic started by: JMR on November 24, 2012, 05:10:37 AM

Title: lasso selection
Post by: JMR on November 24, 2012, 05:10:37 AM
I voted for an irregular form selection tool, so THANKS.
But I just can't manage to do fine with the lasso tool unless you have a very steady hand or a digitizing board instead of a mouse. So I'd be thankful if polygonal selection by entering vertices of a fence was also possible as it works for image-masking
Title: Re: lasso selection
Post by: EMULAT3D on February 27, 2014, 07:59:03 AM
+1

I have been doing a lot of manual clean up on the dense point cloud meshes lately and a polygonal selection tool would be a great addition. Like JMR said, sometimes you need more control and freehand just doesn't cut it.
Title: Re: lasso selection
Post by: Pixel UAV on August 28, 2014, 12:03:45 AM
+1

bit late on the topic, but i would really like to see this feature.  would make cleaning up faces a whole lot easier.  Currently i am just rotating the model and using the square select tool.  slow and annoying