Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: WinterGuy on December 02, 2012, 03:17:35 AM

Title: Windows 8 crash and burn with 32bit demo
Post by: WinterGuy on December 02, 2012, 03:17:35 AM
I downloaded the demo earlier today(the 32bit ver) it runs fine on a windows 7 computer(minus the occasional "out of memory" issue which is to be expected. I thought that I would give my other laptop a shot which has windows 8. After running the program all works up until the mesh is almost generated in the build geometry phase then... complete and utter crash of Agisoft unless the minimal settings are being used. Now I just installed the 64bit version and everything works great but I am curious as to why it crashes. Now I know a 64bit system can run like 2x the ram but if a lack of memory was the issue why did I not get the same error message "out of memory". Any ideas?