Agisoft Metashape

Agisoft Metashape => Bug Reports => Topic started by: mwendell on July 12, 2018, 12:41:49 AM

Title: color misalignment on meshes from imported points
Post by: mwendell on July 12, 2018, 12:41:49 AM

I'm importing scan points from Recap (.pts file), and meshing them in Photoscan Pro. I leave "Calculate Vertex Colors" turned on.

When I leave the face count at 0, Photoscan generates a very high face-count mesh (244 million polys), and takes many hours to finish. However, the RGB values on each of the vertices is correct, and looks good. The data is just too dense.

So when I mesh again and set the mesh count down to something lower (like 2 million polys), the process finishes much quicker and generates a usable mesh. BUT - the color mapping is wrong. It looks like an indexing problem, as if the decimation screwed up the proper spatial position of the colors on the mesh.

Picture included.

Using Pro v1.4.2 build 6205 on Win10.

Title: Re: color misalignment on meshes from imported points
Post by: Alexey Pasumansky on July 12, 2018, 02:05:49 PM

Hello mwendell,

Can the issue be reproduced on the smaller point cloud? If so, then probably you can share the example to support@agisoft.com. Meanwhile we'll try to reproduce the issue on high-poly model of the similar size.