Agisoft Metashape
Agisoft Metashape => General => Topic started by: FredR on August 14, 2018, 05:28:45 PM
-
Hello,
PS automatically fills holes, even large ones, when building mesh from dense cloud.
I don't see a parameter in build mesh to control hole filling with Arbitrary (3D) surface type.
Any help would be appreciate.
Thank you!
-
Anyone can help on this issue ?
-
Hello FredR,
For the experimental (visibility consistent) mesh generation operation it is not possible to disable hole filling.
Also hole filling cannot be disabled when mesh is generated from the sparse point cloud.