Agisoft Metashape
Agisoft Metashape => General => Topic started by: 3DFranz on August 17, 2018, 03:10:42 PM
-
I would need some Advice how to PrePare an Agisoft OBJ File for 3D Printing.
It is an Landscape Model with Buildings, as example shown in the Screenshot.
(http://)
The Model should be Printed in about 50 x 50 x 10 cm.
Any suggestions about the wall-thickness, or the Software to use for preparing the model for Printing?
-
Hello 3DFranz,
Seems like a similar thread has been recently started:
http://www.agisoft.com/forum/index.php?topic=9543
There are also some old, but hopefully helpful threads related to 3D printing and adding thickness to the meshes from PhotoScan:
http://www.agisoft.com/forum/index.php?topic=855
http://www.agisoft.com/forum/index.php?topic=2049
http://www.agisoft.com/forum/index.php?topic=4257
-
Thank you Alexey for our reply.
I missed that recent topic.
Thx for your help.
Best regards