1
General / gap in the alignment process
« on: January 04, 2015, 06:48:36 PM »
hello everyone ,
i'm doing some tests with a 3 camera setup & a turntable using, i'm facing the same problem with everything i scan, which is there is an area around the model that doesn't get images aligned , in this attached model, i took a shot every 10 degrees , im not worried about the model itself since its a bit shiny but i'm worried about the process as a whole , hope some one can give some input on how to get around this & why i am getting this glitch
i'm doing some tests with a 3 camera setup & a turntable using, i'm facing the same problem with everything i scan, which is there is an area around the model that doesn't get images aligned , in this attached model, i took a shot every 10 degrees , im not worried about the model itself since its a bit shiny but i'm worried about the process as a whole , hope some one can give some input on how to get around this & why i am getting this glitch