Messages

1

General / Re: build a good texture

« on: May 15, 2015, 03:07:38 PM »

Hello,

I understand I need to take a photo as clean as possible.
If it is not possible to take crisp photos, then I need to mask them up manually.

The PS source takes up too much disk space.
I usually delete a project data if the result was not good.
That is why I deleted the sources.

2

General / Re: build a good texture

« on: May 14, 2015, 03:38:59 PM »

Those photos were taken quite a long time ago.
I am afraid I can not upload the sources.
They were not good so I deleted the sources.

But I understand how PS calculate to generate a texture.
I think masking and reducing the number of photos are the best option so far.

Thank you everyone for the help.

3

General / optimize camera alignment

« on: May 12, 2015, 02:30:47 PM »

Hello,

In the optimize camera alignment dialog box, Fit k4 is not activated by default.
That means k4 does not usually need to be optimized?
I am not sure which check box to tick to get an better alignment.

4

General / Re: build a good texture

« on: May 12, 2015, 11:00:55 AM »

Hi,

Thank you for your advice.
I will use a polarizer.

I am just curious.
How  Photoscan calculate during texture generation.
I thought Photoscan uses only the center of the picture.
If the center of the picture was well focused, I thought I could get a crisp texture.
 

5

General / build a good texture

« on: May 11, 2015, 01:52:21 PM »

Hello,

I am trying to generate a good texture.
But no matter how I try, the texture is mixed with blurred and sharpened area.
How to make a crisp texture?
My photos are mostly center focused.
camera: NiconD800     28mm    f16    ISO400
Mapping mode: Generic
Blending mode:  Mosaic