Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Krzysztof

Pages: [1]
1
General / Shape boundary
« on: October 30, 2018, 01:48:34 PM »
Hi,

I'm gettin an unexpected issue while trying to set an imported DXF/KML/SHP shape as an outer boundary of orthomosaic - the "set boundary type" option is disabled.
Why is that happens? Is there any limitations with imported files to use them as a boundary?

2
General / Re: Help exporting points
« on: July 10, 2018, 08:04:03 AM »
Hi, try to export in PTS and then sample file in other software - ex cloud compare. Try different space between points to get result you expect.
Personally I think you will need also divide file into parts.

3
General / Re: RAIL LINESURVEY-Single line of Images (20km) with GCP's
« on: July 10, 2018, 08:01:27 AM »
From my experience it's a really bad practice ;). I think you should run at least 3 lines. Also GCP's should be placed not only along the line, but also on the edges. Ex. 3 GCP's every 200meters of rail line.

4
General / Re: Problem with align of forested images
« on: June 26, 2018, 01:50:21 PM »
From our experience increasing overlap won't help.
If we spot some forest areas while flight planning we usually plan another flight with higher level.
Ex. base flight at 60meters and another above forest at 250-300 meters. Then we combine these two sets of photos in agisoft. You won't lose as much accuracy - I think 5-6cm GSD at the tree is still very accurate ;).

Pages: [1]