1
General / Re: Fixing overlapping meshes in 3D model produced by "split in chunks"
« on: August 08, 2018, 01:32:50 AM »
Sorry for the delay, What I have done in the past is un register the geo-tagged images in one of my chunks. You should see a (T) where the (R) was at. Then click on the blue cross icon to the right of the icon that allows you to move/ rotate/ resize. That will allow you to move the layer up down or rotate it to match up with the other layer (chunk)
Also be sure to click the icon on the far right that allows you to show aligned chunks
Also be sure to click the icon on the far right that allows you to show aligned chunks