Messages

1

General / Re: tilted plane

« on: March 15, 2018, 10:09:43 PM »

Was there any solution for this Problem, because we have the same issue and can't figure out a solution....

We suggest it could be a rolling shutter problem.......

2

General / Re: Problems with DJI Pictures to build an correct elevation model

« on: March 14, 2018, 12:04:35 PM »

Thank you for the quick reply.
The script just works fine and i get the correct hight values.
But the orientation of the TiePoints are still completly wrong.
Both surfaces should be flat, but they are still at an angle......

Does anyone has an idea why this mistake occurs?

Both surfaces were scanned at the same place on different days.
If you look from the top view the surfaces align very good, but if you look from the side view they are not aligned and are placed in an angle to each other.....

3

General / Problems with DJI Pictures to build an correct elevation model

« on: March 13, 2018, 06:40:16 PM »

Hi,
im relatively new to agisoft.
We used the Software UgCS and a DJI Phantom 4 to genarate pictures for photogrammetry.
The picturesets were taken on two diffenrent days. The problem is, when i import them to agisoft following along the tutorial the two chunks have a very strange offset to ech other, even though they were taken at the same place. Also when aligned the second pointcloud has an completly wrong orientation in the view.

When looking through the Altitudevalues, they are also strange, because we never flew over 50 meteres hight.

The problem is hard to explain, i'll attach some pictures.....

I hope sombody can hlep me with my problem