Messages

1

General / Re: Network processing 99% Too long

« on: October 14, 2019, 12:05:42 PM »

Hi,
I've got the same issue. Server work blocked at 99% after less than 40 min of the "match photos" process for less than 300 photos. All is good on the server monitor, except that my three nodes are in "ready" status. The network connection speed is 10 Go (between nodes and data location).

2

General / Re: Orthomosaic fail with no error message

« on: September 05, 2019, 10:15:49 AM »

Hello Alexey,

The step that failed was the photo orthorectification in the orthomosaic generation. I think that my mistake was to change the coordinate system (WGS 84 to WGS 84 UTM zone 20, in my case) at the orthomosaic step. Thus, I change the coordinate system at the DEM generation step and it worked perfectly. I tried the same process with an other data set in RGF 93 and it worked well too.

3

General / Re: Orthomosaic fail with no error message

« on: August 28, 2019, 01:13:52 PM »

I finally managed to generate an orthomosaic from my data. The issue came from my coordinate system but I don't know exactly why. My cameras are in WGS84. Then, I generate a DEM in WGS 84/UTM zone 20N (the best proected system for my data) and finally I created the orthomosaic in the same coordinate system than the DEM. It worked perfectly well. I hope it may be of some help for the next persons that will meet this issue.

4

General / Re: Orthomosaic fail with no error message

« on: August 26, 2019, 01:01:44 PM »

The DEM generation looks very fine and its coordinate system is the same than the one of the cameras. The area of interest is included in the boundaries of the box in the Model view.

5

General / Re: Orthomosaic fail with no error message

« on: August 26, 2019, 11:07:21 AM »

Thanks for your quick answer Alexey. I'm using the 1.5.4 version.

6

General / Re: Orthomosaic fail with no error message

« on: August 26, 2019, 10:52:15 AM »

Hi I'm Arnaud,

I know that this topic is quiet old but I had the same issue and I tried everything that was advised previously (verify coordinate system, check the bounding box) but the orthomosaic still failed to generate after 30 min. I had no error message. I attached the log file of the whole process.

Thanks for your help.