Forum

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MD

Pages: [1]
1
General / Dense Point Cloud Processing cut off a lot of points
« on: October 27, 2020, 10:17:37 AM »
Hello everyone,

I have my Agisoft Project with 7200 Fotos, splitted in 9 chunks. I have used Highest Accuracy (70,000 and 20,000) for alignment. After Dense Cloud proccesing (High Qualty), one part on point cloud is not generated. Tried both Agressive and Mild filtering. I quess the reason is insuficient number of photos in this area. Also tried to realign some of the fotos, but without success. Is there a way to change somtehing manually (manual adding of Tie Points)?

Pages: [1]